Case for the Pi-Hat module
The case for the pi hat module is quite simple and easy to put together, the kit comes with all the hardware needed to attach the module itself and the cover. Covers are available in a few different colours. If your colour is not available, Either print your own or send me a message.
​
Base and cover are printed in PLA. You will need to Insert the Threaded inserts yourself.
Features...
The Pi-Hat case has been designed to be super simple, consisting of only Two parts. The Base has mounting space and threaded inserts for the Pi-hat PCB and raspberry Pi, there is also a through hole for any cables you wish to connect and also a channel for a cable tie to secure them.
The lid of the case is fixed on with three screws and it also has a flat area for mounting buttons or custom LEDs if you wish to.
To mount the case to your cabinet there are three countersunk holes for screws. The rear has an opening to access the sd card.
Buy online....
Alternativly print your own Yourself.....
I have made the .STL files available on a few of the well know 3d model platforms, If you wish to download them and print your own case you are free to do so. On Makerworld I have uploaded the printer profiles for Bambu Printers.
How to put together...
Step by step guide on how to put the Pi-hat case together
Threaded inserts...
The case has a total of 8 threaded inserts that are needed to assemble it. Using the tip of your soldering iron heat the insert over the hole and it will slowly start to sink into the hole, once it almost flush with the surface remove the heat. Use a pair of long nose pliers to keep it in place and as not to pull it back out with the soldering iron. Make final ajustments with the pliers if needed.
Final assembly...
To finish off the case you will need to install the PCB itself....